Hey y’all.

Brand new to welding/fab work. Had about an hour to learn how to use and dial techniques in on the plasma cutter, which wasn’t enough to TRULY make a difference. All that said, I’m proud of this and I am eager to see what I can eventually do. As a disclaimer: 3/8th inch steel, 45 amps, 65ish psi, I drug every cut, the sides were straight cuts, the top and bottom were bevels, and the square and circle were freehand. I know I was moving too slow, indicated by the high accumulation of dross.

Any tips/tricks y’all can offer?