Edit: Solved. Despite it extruding normally on load and a .4 cleaning pin running through perfectly, it seems to have been a minute clog. Replacing the nozzle has it printing smooth as can be again. Title says it. Printer: Sovol SV06 Plus Ace Nozzle: Hardened Steel 0.4mm Fuzzy skin not enabled. Filament dried overnight, multiple filaments and models tested. Sliced in OrcaSlicer using saved presets I always use; however it seems to have started after I imported some stock filament profiles and tried one on Polymaker ASA, though I can't conclusively say that was the start. I've re-run calibration multiple times, etc.. Any suggestions/ideas? submitted by /u/giveAShot [link] [comments]