ESP32 dev board ports not appearing on arduino ide hello. I have recently made my first personal ESP32 board. The smaller one is for a flight controller using ESP32 S3, and the bigger one is for a TFT screen using ESP32 WROOM. The PCB works as intended, no shorts, ch340C receives 5V, and ESP32 receives 3.3V. Everything is grounded and wired properly. But when I plug the USB into my pc no ports are detected in either device manager and arduino ide. Basically, I can't programme it. I reinstalled the CH340 drivers, changed it twice, changed pc's, changed the USB cable and the onboard port, and both ESP32s were taken from a working commercial ESP32 board. If you have any idea of what might be causing this problem, please share it.…