Hello all, I have a problem with a server room I inherited. There is a two post rack with two 24 port patch panels. All of the lines are ran without a service loop and have about 3 inches of slack. I was going to mount them on the back of a new 4 post rack and use a RJ45 to connect to it and then the other end to a keystone connector that would go into the new Panduit modular rack. This way I could clean up the wiring and labeling. The way it looks now is awful and all over the place. Please advise if this would be a workable solution, as this company cannot afford to pull all new cables as of now. Thanks in advance. submitted by /u/Far_Combination7686 [link] [comments]