Hey community!

I'm running (or at least trying to) a Supermicro PWS-605P-1H (600W, 1U, 24-pin ATX output) on a consumer ATX motherboard without PMBus support. When I apply mains power, the PSU makes a clicking noise at a regular 2–3 second interval and the system never powers on.

What I have done so far:

tested a second (also refurbished) PWS-605P-1H -> same

Connecting the PSU to mains without anything else connected -> No clicking

Without anything connected: Grounding Pin 16 / PS_On -> PSU Fan spins up and seems to power on

A few questions:

- Is a minimum load required on this PSU, and if so, which rails (+12V, +5V, +3.3V)?

- Could the lack of PMBus communication cause the PSU to refuse to start, or is PMBus purely for remote monitoring/telemetry?

- Has anyone successfully run this PSU (or similar Supermicro units) on a consumer board? Any gotchas I should know about?

Thanks!